Stryker 4700, Maintenance Manual

Page: 7 / 159

Unpacking and Initial Set–Up Procedures
6
UNPACKING INSTRUCTIONS
Refer to unpacking instructions attached to the bed inside the crate.
SET–UP PROCEDURES
It is important that the Stryker Adel Maternity Bed is working properly before it is put into service. The following
list will help ensure that each part of the bed is tested.
Plug the bed into a properly grounded, hospital grade wall receptacle.
WARNING
The Stryker Adel Maternity Bed is equipped with a hospital grade plug for protection against shock hazard.
It must be plugged directly into a properly grounded three–prong receptacle. Grounding reliability can be
achieved only when a hospital grade receptacle is used.
Ensure the siderails raise and lower smoothly and lock in the up position.
Ensure that the brakes hold when the brake pedal is engaged.
Test each function on the (optional) hand pendant to ensure that each function is working properly.
Beds equipped with nurse communication siderail control option only:
Plug the interface cable into the 37 pin connector in the litter frame at the head end of the bed, and into
the ”Patient Station”, ”Head Wall”, ”Docker Station”, or equivalent (whichever applies).
Run through each function on the siderail control panels to ensure that each function is working properly.
NOTE
To prevent a low battery condition when the bed is not plugged in, position the cord out switch at the head
end of the bed to the off position. The switch is identified by the label shown below. If the switch is not posi-
tioned as shown below and the bed power cord and pendant cord are unplugged, the life of the back–up bat-
tery will be significantly reduced.
If the siderail lights LED (located on the outside of both siderails) is flashing, the Nurse Call battery needs
to be replaced. The battery is located on the patient’s right side at the head end of the bed. No tools are
required to replace the battery. Unplug the bed power cord from the wall socket and replace the battery. After
replacing the battery, verify the siderail lights LED is no longer flashing and operates normally when the differ-
ent light settings are selected.