Struers Accutom-50, User Manual

Page: 61 / 226

Accutom-50
Instruction Manual
57
Error Messages
Display Message Explanation Action
Cutting or grinding method not
selected START Select a method and press

was pressed before a
cutting or grinding method was
selected
START
Dressing range exceeded

again
The parameter Y-distance is set to a
value larger than the possible
movement of the table Adjust the Y-distance and press
START

X-MIN sensor not activated
again
The inductive sensor cannot detect
the end position of the X-table Check for mechanical blockage of
the table. If that is not the case, call a
Struers service technician
X-MIN sensor not deactivated The inductive sensor for the X-posi-
tion cannot be deactivated Check for mechanical blockage of
the table. If that is not the case, call a
Struers service technician
Encoder error The Y-table does not move, or the
encoder is defective Check for mechanical blockage of
the table. If that is not the case, call a
Struers service technician
Cutting/grinding motor overloaded The main motor has been exposed
to a high load for a long time Wait until the motor has cooled
down. “Cutting motor ready after
overload” will be shown on the
display. Adjust process parameters
to avoid repetitions
Machine Problems Explanation Action
The recirculation pump is not
working correctly The water level in the recirculation
tank is too low Check that there is sufficient water in
the recirculation tank
The water outlet is clogged Remove the cooling tubes and run
the recirculation pump.
Flush the cooling tubes with clean
water before replacing
The recirculation pump is
contaminated with cutting residue Flush the pump with clean water by
gently pressing fresh water into the
inlet tube