If the Emergency stop is activated on the main machine, the Cooli-1 pump
also stops.
2.3
Cooling unit pumps safety precautions
2.3.1
Read carefully before use
1.
Ignoring this information and mishandling of the equipment can lead to
severe bodily injuries and material damage.
2.
The machine must be installed in compliance with local safety
regulations. All functions on the machine and any connected equipment
must be in working order.
3.
The operator must read the safety precautions and Instruction Manual, as
well as relevant sections of the manuals for any connected equipment
and accessories.
4.
Only use original Struers consumables as this ensures maximum safety
and prolongs the machine's lifetime.
5.
When working with cooling fluid always observe the safety regulations for
handling, mixing, filling, emptying and disposing of the cooling fluid
additive. Never use flammable cooling fluid. Note that the cooling fluid
can be hot and must therefore be handled with care.
6.
Always wear protective gloves and safety goggles when you clean and fill
up the tank.
7.
The recirculation pump must be disconnected from the electrical power
supply before it can be removed from the cooling unit.
8.
All safety functions must be intact and in working order. If they are not,
they must be replaced or repaired before the machine can be used.
9.
Always use the handle to close the cover.
10. Do not insert your hands through the openings into the water inlet ducts
on the cover.
11. Cooling fluid can be slippery - therefore always keep the area around the
tank clean.
12. If you observe malfunctions or hear unusual noises, switch off the
machine and call technical service.
13. In case of fire, alert bystanders and the fire brigade. Disconnect the
electrical power supply. Use a powder fire extinguisher. Do not use water.
14. Always switch off the electrical power supply and remove the plug or
power cable before dismantling the machine or installing additional
components.
2 Safety
Cooling unit pumps
5
