PRODUCT PLACEMENT / AIRFLOW CONSIDERATIONS / LOAD LINES
8
1. Product Placement
Product can be placed on decking or steps
(risers) within the service display area.
A wide range of product may be displayed.
2. Airflow Considerations: Rear Plenum /
Return Air Grille / Honeycomb
Proper airflow is critical to maintain proper
product temperature.
Proper product placement will allow rear air to
flow over (and around) product to return air grille
at case front. See illustration below for specifics.
Caution! To prevent airflow from blocking venting
slots, place product at least 1” from rear plenum.
3. Load Lines
The load lines represents the maximum height
that product can be place and/or stacked in
case.
Keep product at or under load line to assure that
refrigerated airflow is properly cycled from rear
plenum through return air grille.
Proper product placement will maintain
acceptable product temperature.
See illustration below.
Honeycomb Air Diffusers.
Do Not Block These
Areas With Product
Air Return Duct. Do
Not Block This Area
With Product
Air Return Duct. Do
Not Block This Area
With Product
