14
R
888 Porter Rd. Muskegon, MI 49441 Phone: 231.798.8888 Fax: 231.798.4960 www.structuralconcepts.com
REFRIGERATION FUNDAMENTALS
Refrigeration Access, Connections &
Servicing
Assembly or disassembly and servicing to
be accomplished by licensed refrigeration
contractor.
•
Refrigeration Unit slides directly out from
lower section to allow for servicing.
•
Service connections are located in the
Refrigeration Slide-Out (shown at right).
•
Refrigeration Unit is equipped with
evaporator pan for case condensation.
Insure evaporator pan is plugged in 110V
receptacle inside base, and positioned
under PVC drain and on base frame.
•
When pulling or pushing unit in or out under
the case, use caution to avoid damage to
copper refrigeration lines, hoses and cable.
•
Insure that the flexible drain hose is fully
inserted into the slot of hose support for
proper drainage
.
See illustration on next
page for general location and specifics.
Temperature Control Module
•
Temperature Control Module is located in
the Electrical J-Box.
•
The temperature is controlled by the
Temperature Control Module. It is located
at lower-right area (from the rear) of the
Drop-In Refrigerated Section. See top-right
illustration for general location.
•
If a temperature setting change is required,
refer to the instructions for the
CPC®
(ESC3) Temperature Control Programming
operating section of this manual
•
Note: See Technical Data section of this
manual for proper settings to maintain
product temperature per model.
Slide
Out f
or
Serv
icing
Electrical
J-Box
Light Ballast
Main Power
Switch
Temperature
Control
Module
Temperature
Control
Module
