Page 10 of 16
EQUIPMENT DAMAGE
Never connect the USB power port directly to a computer USB outlet. Doing so may cause damage to
both the power port and USB outlet.
Operation of LED Light
1. Slide the USB/LED slide switch to the right.
2. Slide USB/LED switch to middle to turn off the LED light after use. Failure to do so may damage
the internal battery because of over discharge.
Jump Starting an Engine
1. Make sure your vehicle is a negative ground system. If it is a positive ground system vehicle or
you are unsure, please consult the vehicle’s owner’s manual.
2. Check battery capacity status by pushing the battery capacity check button to ensure that the
battery is fully charged
3. Turn off the vehicle and all accessories in the vehicle.
4. Engage the park/emergency brake of the vehicle.
5. Engage the transmission in park mode for an automatic transmission vehicle or engage the
transmission in neutral for a manual transmission vehicle.
6. Place the jumpstarter on a flat, stable surface close to the battery of the vehicle.
7. Plug the booster cable into receptacle of the jumpstarter (see below).
8. Connect the negative (black) clamp from the jumpstarter to the chassis of the vehicle (fig B).
9. Connect the positive (red) clamp from the jumpstarter to the positive (+) terminal of the battery in
the vehicle
(fig B).
