Page 10 of 15
6. Recharge the jumpstarter immediately after use. Refer to Recharging the Jumpstarter with AC
Charger.
Operating USB Appliances
⚠
CAUTION
EQUIPMENT DAMAGE
Never connect the USB power port directly to a computer USB outlet. Doing so may cause damage to
both the power port and USB outlet.
Using the USB Port
1.
Check battery capacity status by pushing the “BATTERY” button to ensure that the battery is
fully charged.
2. Plug one end of USB cable (not provided) into the USB power port and other end to the USB-
chargeable device (e.g., MP3 player).
3.
Press the “USB” button to turn on the USB power. There will be an indication light on LCD
screen to advise the USB power ports are activated.
4. Press the USB button again to turn off USB after use. Failure to do so may discharge the
internal battery to dead.
5. Recharge the jumpstarter immediately after use.
Operating the LED Light
1.
Press the “Light ON” button to turn on the LED light
2. The LED light has multiple functions. Press the desired light function button to select the desired
function.
3. Turn off the LED light after use. Failure to do so may discharge the internal battery to dead.
4. Recharge the jumpstarter immediately after use.
Jumpstarting an Engine
1. Make sure your vehicle is a negative ground system. If it is a positive ground system vehicle or
you are unsure, please consult the vehicle’s owner’s manual.
2. Check the battery status before boosting engine
by pressing “ BATTERY” button.
3. Turn off the vehicle and all accessories in the vehicle.
4. Engage the park/emergency brake of the vehicle.
5. Engage the transmission in park mode for an automatic transmission vehicle or engage the
transmission in neutral for a manual transmission vehicle.
6. Place the jumpstarter on a flat, stable surface close to the battery of the vehicle.
7. Connect the negative (black) clamp from the jumpstarter to the chassis of the vehicle.
8. Connect the positive (red) clamp from the jumpstarter to the positive (+) terminal of the battery in
the vehicle.
9. If the connection is correct, the green indicator on positive side panel is on, the move to step 11.
