Page 7 of 10
Assembly
1. Locate all parts as shown in the Parts Diagram. Use caution, as the points are sharp.
2. Place the U-Style Hitch Bracket (8) around the Drum Body Weldment (1). Place t he Joint Bushing
Weldment (3) over axle and attach with Bolts (5), Flat Washers (6), and Lock Nuts (7) on each
side.
3. Place the T-Style Hitch Bracket (12) against the U-Style Hitch Bracket (8) and attach using Bolts
(9), Flat Washers (10), and Lock Nuts (11). Tighten all hardware securely. Check all hardware
periodically to assure tightness.
4. Fill the drum with water to achieve the desired weight. Install the Plug (2) and the Washer (13).
5. Grease or oil the bushings as needed.
Before Each Use
Always check for damaged or worn-out parts.
Grease or oil the bushings as needed.
Check hardware for tightness before each use.
Maintenance
Maintain your aerat or. It is recommended that the general condition of any aerator be examined
before it is used. Keep your aerator in good repair by adopting a program of conscientious repair and
maintenance in accordance wit h the recommended procedures found in this manual. Keep all cutting
tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to
bind and are easier to control. Keep handles dry, clean, and free from oil and greas e. Drain water
completely from the drum after eac h use.
Parts Diagram
5
6
7
