1200-LB. CAPACITY DUMP CART
OWNER’S MANUAL
1200-LB. CAPACITY DUMP CART
OWNER’S MANUAL
7.
DO NOT use the equipment when tired or under the influence of drugs, alcohol, or
medication.
A moment of inattention while operating this equipment may result in serious
personal injury.
8. Industrial applications must follow OSHA requirements.
SPECIFIC OPERATION WARNINGS
1. Do not modify the cart in any way.
Unauthorized modification may impair the function and/or
safety and could affect the life of the equipment. There are specific applications for which the
yard cart was designed.
2. Always check for damaged or worn out parts before using the yard cart.
Broken parts will
affect the dump cart operation. Replace or repair damaged or worn parts immediately.
3. Store idle dump cart.
When dump cart is not in use, store it in a secure place out of the reach of
children. Inspect it for good working condition prior to storage and before re-use.
4. Do not at any time carry passengers sit or stand on the cart.
5. Do not exceed maximum load capacity of 1200 lbs.
6. Avoid large holes and ditches when transporting loads.
7. Be careful when operating on steep grades; the cart may tip over.
8. Always operate at reduced speed in rough terrain.
9. Do not operate close to creeks, ditches and public highways.
10. To avoid personal injury and/or equipment damage, DO NOT EXCEED 10 MPH.
11. Always use caution when loading and unloading the cart.
12. Only tow with recommended vehicles (Lawn/Garden Tractors and ATVs).
13. Always secure and lock dump cart to the vehicle hitch before operating.
ASSEMBLY
Take all parts out of the shipping crate and inspect components to ensure there are no missing
pieces before starting to assemble the dump cart follow steps 1 through 9
Tool Required
• Pliers
• Screwdriver
• Wrench
STEP 1 Attach Bottom Panels and Support Tubes (See Fig. 1)
1. Put the left bottom panel and right bottom panel together.
2. Attach the support tubes to the panels using eight sets of M8x40 screws and M8 nylon lock nuts.
Loosely tighten the nuts.
STEP 2: Attach Tongue Support (See Fig. 2)
1. Attach the tongue support I and Tongue Support II to the bottom panels using M8x50 screws
and M8 nylon lock nuts. Loosely tighten the nuts.
STEP 3: Attach the Wheel Axle Support (See Fig. 3)
1. Put together the two wheel axle support stands, attached them to the bottom panels using eight
sets of the M8x20 hex bolts and M8 nylon lock nuts. Loosely tighten the nuts.
2 of 7
3 of 7
Fig. 3
Fig. 1
Fig. 2
Tongue Support II
I
Tongue support II
1pc
I
