Page 9 of 15
Assembly Instructions
⚠
WARNING
Be sure the wall is at least 12 inch (300mm) thick dry, cement - grouted firm wall or on 4 by 5 inch
wood studs / joists.
INSTALLATION INSTRUCTIONS
Use wall bracket of wall mount assembly as a template for locating the holes to be drilled on
mounting surface.
After determining the hole locations, use an appropriately sized drill bit and, drill holes through
mounting surface. Reference acceptable mounting surfaces and appropriate drill bit sizes for
application.
Attach wall mount assembly to mounting surface using hardware
not provided
. It is
recommended that a minimum of grade 5 fasteners be used. The following are acceptable
surfaces for mounting wall mount assembly.
STEEL SURFACE
- When mounting to a steel surface of sufficient strength, such as a vertical l-
beam, drill through holes at pre-marked locations, using a 9/32" drill bit. Attach wall mount
assembly to mounting surface using 1/4"-20 hex screw of appropriate length, in combination with
1/4" flat washers, 1/4" lock washers, and 1/4"-20 hex nuts.
MASONRY SURFACE
- When mounting to a masonry surface use a 1/4" expansion type bolt or
1/4" masonry lag with shield. Drill holes at pre-marked locations using appropriate sized drill bit as
recommended for fastener.
NOTE:
HARDWARE NOT SUPPLIED
1. Install the wall bracket on the strong wall.
2. Install the fan motor on the angle support bracket.
3. Assembling the back guard, blade, and front guard to the motor. Secure guard with set screw.
