Wakeup Date
:
Use the
0~9
buttons to enter the date for the timed event.
Wakeup Time
:
Use the
0~9
buttons to enter the starting time.
Duration
:
Use the
0~9
buttons to enter the duration of the timer.
When all settings have been made, use
pq
to move the highlight to
Save
and press
ok
to confirm.
To quit the timer without saving your settings, move the highlight to
Cancel
.
7.3.5 Parental Lock
This menu allows you to protect the installation menu and/or channels with a PIN code. You can also
enter a new PIN code in the
Parental Lock
menu.
Use
pq
to select
Parental Lock
from the
System Setup
menu and press
ok
to proceed. You will be
asked to enter your PIN code.
(DEfAULT PIn: 1234)
Menu Lock
:
Locks the installation menu. You can set
Menu Lock
to
On
or
Off
.
Parental Rating
:
Choose between:
Off
,
4 years
and up to
18 years
. Channels with a parental
rating above the chosen age will be protected with a PIN code (if available in
your local broadcast.)
New Password
:
Enter your new PIN code (4 digits) here.
Confirm Password
:
Re-enter your PIN code here to confirm.
7.3.6 oSD Setting
This menu allows you to change settings for:
OSD Timeout
and
OSD Transparency
.
OSD Timeout
:
Sets the duration time of on screen banners and messages remove. The
range is
1~10
seconds or
Always On
.
OSD Transparency
:
To set the OSD transparency from
Off ~ 40%
with 10% steps.
Load Default OSD Setting
:
Press
ok
to clear all OSD settings and reset to default values.
7.3.7 Audio Description Setting
This menu allows you to change settings for:
AD Service
:
Off
or
On
. If set to
On
then receiver will allow you to use Audio description.
Use AD as default
:
Off
or
On
. If set to
On
then audio description is enabled by default.
AD Volume Offset
:
To set the AD Volume Offset
-3 ~ 3
with 1 step. Default value 0.
7.3.8 Auto Standby
Auto Standby is a feature that helps you reducing power consumption. When set to
30Min/1 Hour/2
Hours or 3 Hours
, the receiver will switch to standby if it doesn’t receive any commands during this
time. Set
Auto Standby
to
Off
to deactivate the automatic standby function.
7.4 Tools
Press
MEnU
in viewing mode to enter the
Main Menu
.
Select the
Tools
submenu with
pq
and press
ok
or
u
to enter.
Use
pq
to highlight the submenu of choice and press
ok
proceed.
Press
EXIT
to leave.
17
