Strong SRT 6011, User Manual

Page: 12 / 27

PART 1 • English
7
English
Connecting a dish on a motorized positioner to your receiver (Fig. 9)
Fig. 9
Another possibility for watching programs from multiple satellites is by mounting a dish to a
motorized DiSEqC 1.2 positioner. Have your dealer mount the dish to the positioner, set the correct
angle of the elevation and let him set the center point for your positioner. Connect the LNB with
a coax cable to the LNB IN connector of the positioner, and connect the OUT connector of the
positioner to the LNB IN connector at the back of your receiver.
3.4 Connecting to serial cable for downloading software
Fig. 10
Connect the RS-232 connector on the back of your receiver to the Serial port of your computer using a
serial cable. Instructions how to download software can be found on our website www.strong.tv (support
> download). However, this receiver can download new system software automatically by satellite.
4.0 STARTING UP
Ensure your satellite receiver is correctly connected to your television and dish, and that your
satellite signal is of good quality. (If you are not sure about this then ask your local STRONG
dealer to check your installation or satellite signal.) Confirm that the power plug on the receiver is
plugged into the wall outlet. Turn on the receiver. It is recommended that you perform the first time
installation following the Installation Wizard step by step. It will help you to easily achieve system
configuration and channel installation. If you are a professional installer then you can skip wizard by
pressing
MENU button and set-up channels using the Installation menu.
4.1 Language Selection
Press UP/DOWN to choose your language, press OK to confirm. The Select Satellite menu will
appear. Future installation steps are depending from satellite where your dish is aimed.
4.2 Select Satellite
a) Your dish is aimed to ASTRA 1C, 1E, 1F or HOT BIRD satellite.
Press
UP/DOWN to select the ASTRA or HOT BIRD satellite and press OK button. Follow the
instructions. When you have fixed your dish at correct direction choose NEXT and press the OK
button. The Channel Setup menu will appear.
b) Your dish is aimed at another satellite
Select
Other in Select satellite menu and press OK , more satellites will be listed. If you select one out
of the satellite list, the Configure Antenna menu will appear, please set the LNB Type, LNB Low Freq,
LNB High Freq, Band control, Polarisation control, DiSEqC Switch and Antenna mode.