Strong SRT 6006, User Manual

Page: 18 / 26

PART 1 • English
14
If your antenna is primed to Hotbird 1, 2, 3, 4 at 13E then enter following parameters:
Frequency: 12476; Polarity: H (Horizontal); Symbol rate: 27500
Move menu focus to OK and press OK button on remote control. The receiver will check availability
of the software update on air and load the latest software, if available. Do not switch power off and
do not disconnect the receiver from the aerial during update process. Availability of the software
update is subject of local broadcast condition and may not work in all countries. Contact your
vendor to find out more about this function.
5.3.5.3 Update through PC to STb
1. Connect Computer to receiver (receiver must be power off) with a 9-pin cross cable
(two females).
2. The computer will follow the steps below:
Start->Programs->Accessories->Communications->Hyper terminal
Then choose “COM1” or “COM2” according to which port you are using in the computer
and port setting as follows:
Bits per Second:
115200
Data bits: 8
Parity: None
Stop bits: 1
Flow Control: None
3. In Hyper Terminal menu select “transfer” item and then press “send file” item. Select the
file with the new software ( *.UPD ) you want to download and choose the protocol
“1K X modem”. Finally press OK and a download menu will appear on the computer
screen. Power on the receiver, then the download process will start.
4. After about 2.5 minutes, the message “OK, Reset” will appear on the computer on Hyper
Terminal window, which means the download has completed successfully.
5. Power off the receiver and then unplug the RS-232 interface.
NOTE: INCORRECT OPERATION MAY CAUSE UNREPAIRAbLE DAMAGE TO THE RECEIVER.
1. DO NOT POWER OFF THE RECEIVER DURING THE PROCESS OF DOWNLOAD.
2. DO NOT PLUG IN OR UNPLUG THE RS-232 INTERFACE WHEN RECEIVER IS
POWERED ON
5.4 Timer
You can set the timer to make the receiver perform designated actions including timer based wake
up or sleep instructions to the receiver.
Use the
UP/DOWN buttons to select timer. Press the RED key to activate/inactivate current timer.
Press the OK button to enter your selected timer settings.
Action: You can select the following functions:
“Power On”: The receiver powers on at the designated date and time within defined channel.
“Time interval”: The receiver switches on at the designated date and time, displays the channel and
then switches off at the designated date and time (The value set at the end time).