15
English
14
6.1 Getting Started
6.1 Getting Started
(When the DiSEqC Motor parameter is set as USALS <Figure 6.1.6>)
- Sat Degree :
Satellite location.
- Antenna Position :
Press .
- Goto Reference :
Move the dish to the reference 0 position.
- Antenna Longitude :
Your longitude at present.
- Antenna Latitude :
Your latitude at present.
ҫ
Note : You need to know what LNB you are using to correctly set the L.O. (local
oscillator) frequency.
ҫ
Note : You need to understand how your receiver is connected to properly set the
22KHz and DiSEqC.
⊾
When you are done, press the
EXIT
button.
(When the DiSEqC Motor parameter is set as 1.2 <Figure 6.1.4>)
- Satellite
: Select any satellite by pressing
/
buttons.
- Frequency
: Displays the current TP value of the selected satellite.
- Move
: Move the dish position to west/east by pressing
/
buttons.
- Move Fine
: Move the dish position 1 step at a time to west/east by pressing
/
buttons.
- Motor Control
: Control motor by press
button on the remote. <Figure 6.1.5>
⍜
Recalcuate
: Recalculate the position of all other saved satellites relative to the
known position.
⍜
Reset System
: Reset the position of all saved satellites.
⍜
Goto Reference
: Move the dish to the 0 position.
⍜
Disable Limit
: Disable east and west limit.
⍜
Enable Limit
: Enable the saved east and west limit.
⍜
Set East Limit
: Edit & Save east limit by pressing
/
or
buttons.
⍜
Set West Limit
: Edit & Save limit by pressing
/
or
buttons.
- Go To
: Go to the position of the saved satellite.
- Save
: Save the current setting of DiSEqC 1.2 system.
VOL
VOL
VOL
VOL
VOL
VOL
VOL
VOL
VOL
VOL
<Figure 6.1.4>
<Figure 6.1.5>
<Figure 6.1.6>
<Figure 6.1.7>
