Precautions for using the battery
Improper using of the battery will cause leakage. Carefully follow these instructions.
1. Please note the batteries' polarity to avoid short circuit.
2. When the battery's voltage is insufficient which affect the use range, you should replace it with
a new battery. Remove the batteries from the remote control unit if you do not intend to use it
for a long time.
3. Do not use different types of batteries (for example Manganese and Alkaline batteries) together.
4. Do not put the battery into fire, and charge or decompose the battery.
5. Please dispose batteries abide by relevant environmental protection regulation.
2.7 Using the remote control
Use the remote control by pointing it towards the remote sensor. Items between the remote
control and the remote sensor could block normal operation.
Do not cause the remote control to vibrate violently. Also, do not splash liquid on the remote
control, also do not put the remote control in a high humidity place.
Do not place the remote control under direct sunlight which will cause deformation of the unit
by heat.
When the remote sensor is under direct sunlight or strong lighting, the remote control will not
work. If so, please change the lighting or TV's position, or operate the remote control closer to
the remote sensor.
3.0 FIRST TIME INSTALLATION
After all connections have been properly made, switch on your TV. The language selection will appear on
screen. Use
pq
t
u
to select the
OSD Language
of your preference. Confirm with
OK
on your remote
control.
The next screen appears with the
Mode Selection
to select
Home Mode
or
Shop Mode
. Press
OK
and
t
u
to confirm.
Then the next screen appears with the tuner selection. Choose the one you like to use.
Scan type
Select which input source you want to use:
DVB-S
to receive satellite
broadcasts (and if you are equipped with a satellite dish),
DVB-T
to receive
terrestrial broadcasts or
DVB-C
to receive cable broadcasts.
3.1 DVB-S/S2 installation
Satellite Setting
First select the region where you are using the TV. This important to set time zone correct. Use the
t
upq
and confirm with
OK
.
Press
pq
to highlight the satellite your dish is aimed at. Confirm with
OK
to mark the satellite. Use
the
t
upq
buttons to change settings for your satellite installation for each specific satellite. The
signal quality bar on the bottom of the screen allows you to fine tune the alignment of your antenna for
optimum reception. Adjust your antenna for maximum possible signal quality. When the signal cannot
be improved anymore, fix the dish on this position and press the
BLUE
Scan
button to continue.
Channel Search
Press
pq
t
u
to highlight the options of choice and press
OK
to start the channel search.
Scan Mode
Choose between
Default
(recommended),
Blind Scan
,
Network
and
Preset
Channel List
.*
8
