29
Strong Enterprises Owner’s Manual. Para-Cushion model 306 Squadron Seat
11236 Satellite Blvd. Orlando, FL 32837 Tel: (407) 859-9317 Fax: (407) 850-6978
www.strongparachutes.com [email protected]
9.1
Thread the steering line through
the guide ring then through the
grommet in the toggle, starting from
the underside of the toggle (the side
with Velcro®).
Lay the toggle on the riser where it
will be when set, and measure where
the steering line should be tied.
There should be one or two inches
of slack in the steering line after the
rest of the lines are pulled tight.
9.2
“Figure-8” the line through the
grommet and secure with an
overhand knot. If the steering line
is thin, as in the Mid-Lite, or Lite, a
second “figure-8” may be necessary
to fill up the grommet hole.
9.3
Mate the Velcro® to secure the toggle
to the riser.
9.4
For original Para-Cushions (old
style) that utilize a metal ring
instead of cloth toggles, route the
steering lines through the guide ring
on each riser. Zig-zag stitch a 1 1/2
inch loop (trim the excess line) then
slip loop through and over a 1 inch
ring or through the steering loop.
Safety tie each steering ring to the
riser immediately below the guide
ring using seal thread (cotton 24/4),
one turn, single ply.
9. Installing the Toggles
Summary of Contents for Para-Cushion 306 Squadron Seat
Page 35: ......
