Strom HANDYWASH SEHW3KA1, Installation Manual

Page: 7 / 12

G E N E R A L U S E
SEHW3KM1
SEHW3KA1
• Turning the temperature dial towards cold will give you cold water, the further towards cold you turn
the temperature dial the faster the cold water will come out of the tap.
• Turning the temperature dial towards hot will give you hot water, the further towards hot you turn the
temperature dial the faster hot water will come out of the tap however, the higher the flow rate the
cooler the water will be. By pushing the control only slightly towards hot the flow rate will be very low
but the water temperature will be very hot.
REMEMBER: This product, if used incorrectly can scald, if
the water is too hot increase the flow rate by turning the temperature dial further forwards, if it is too
cool reduce the flow rate by throttling the temperature dial backwards.
• Leaving the temperature dial in the central OFF position turns the flow rate and the heater off.
REMEMBER: If you are to leave this product unattended for long periods of inactivity please isolate
the electric supply, and drain the product down. After a draindown please follow the comissioning
procedure again.
• Turning the temperature dial towards cold will give you cold water, the further towards cold you turn
the temperature dial the faster the cold water will come out of the tap.
• Turning the temperature dial towards hot will give you hot water, the further towards hot you turn the
temperature dial the faster hot water will come out of the tap however, the higher the flow rate the
cooler the water will be. By pushing the control only slightly towards hot the flow rate will be very low
but the water temperature will be very hot.
REMEMBER: This product, if used incorrectly can scald, if
the water is too hot increase the flow rate by turning the temperature dial further forwards, if it is too
cool reduce the flow rate by throttling the temperature dial backwards.
• To activate the flow of water from the unit simply pass your hand infront of the control dial, your hand
should pass within 5cm of the device in order to activate the flow.
• Leaving the temperature dial in the central OFF position turns the flow rate and the heater off.
REMEMBER: If you are to leave this product unattended for long periods of inactivity please isolate
the electric supply, and drain the product down. After a draindown please follow the comissioning
procedure again.
M A I N T E N A N C E
Always turn off the power supply before servicing your unit
To ensure a long lasting and efficient product we recommend the following maintenance regime:
• Periodically remove scale and dirt that may build up at the aerator of the faucet or in the sprinkler.
• The filter washer supplied and fitted should be cleaned to reduce any debris build up and ensure good
consistent flow rates.