Strobel VEB100-6, Mechanic'S Instructions

Page: 25 / 42

21
MA_VEB100-6_A2_180618_en
3.6
3.6.1
Presser plates
Setting the presser plates
A t t e n t i o n !
Switch off machine electrically!
The feed plate position is given by the symmetrical position of the angle levers
to the plunger. They should tilt easily and fit closely to the needle plate. The
pressure is approx. 12N, measured at the feed plate center. It can be set
individually for either feed plate at the upper side of the cloth support arm by
means of screws.
3.6.2
The feed plates are pressed downwards when lifting the cloth support arm.
Adjustable eccentric bolts (1) and (2) serve as limit stop.
Setting the presser plate lifting (Fig. 9)
With the cloth support arm being, in its highest position there should be a play
of approx. 2 mm between lever and bolt to guarantee a secure pressing of the
feed plates against the needle plate at any stitch depth setting.
Fig. 9