Installation
• Mark two holes on the wall, indicating the position that you want to install the
heaters. The different distances between the respective holes are:
• Single element models: 300 mm
• Double element units: 660 mm
• The recommended
installation height
is as follows:
• 1500 watt models: 1,8 m — 2,5 m above floor height
• 3000 watt models: 2500 mm — 4000 mm above floor height
• Ensure that you adhere to
all safety distances
as per the diagram in this manual.
• Drill a 6 mm hole about 70 mm deep on both positions
• Fix the L-bend wall brackets using the supplied 6 mm anchor screws. The slotted part
of the bracket goes against the wall and the 5 mm hole against the heater.
Do not
tighten the bracket yet.
• If you mount the heater on wood, or drywall, etc., ensure that you use the
appropriate
screws and isolation between the bracket and the surface.
• Fix the heater to the wall brackets using the supplied M5 washer and hex bolt. Move
the wall brackets either left or right in the slot to ensure a tight fit.
• Swivel the heater to the desired position and tighten the bolts.
• Connect the electrical wire to the supply as per building regulations.
Installation on a portable stand
•
Do not
use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
•
Do not
use the portable stand indoors or near any combustible materials, couches,
carpets, etc.
• Ensure that the electrical cable is secure and not crossing any walkways.
• Remove any wall brackets from the heater
• Fit the Supplied stand bracket to the centre of the heater using the M5 Hex screw.
• Fit the complete unit on the stand using the M10 wing nut
• Let the heater
cool down for 5 minutes
before you move the stand.
Page
!
of
!
www.striking.co.za
7
12