Strider MX 3, Operating Manual

Page: 49 / 102

49
Issued: 24.02.2005
S T R I D E R M X Things to know
Batteries mostly discharged = more charging current
Batteries half discharged = decreased charging current
Batteries fully charged = current to keep up battery charging
When the batteries are full, only the current required for battery
charging flows, which means that battery overcharging is prevented.
The battery charger regulates the voltage (Volt) and the current
(Ampere) from your mains connection down to the voltage
required for charging your batteries (24 Volt).
The amount of charging current required is dependent on the
charging state of the discharged batteries.
The entire power supply is taken over by
two 12 V batteries. These are located below
the motor cover under the seat.
The batteries used in the Strider are known
as batteries for cyclic use. Only enclosed
maintenance-free deep cycle batteries are
used.
Batteries
13.1 The battery charger - functioning principle
13.2.1 What are batteries for cyclic use?
Batteries for cyclic use are designed, in contrast to starter batteries
as used in cars, so that they deliver continuous energy over a longer
period of time and allow a considerable number of charging phases.
13.2.2 When do the batteries achieve their maximum performance?
Fixed cycle batteries achieve a maximum performance after four
or five charging and discharging cycles. Only at this point is their
internal chemical equilibrium achieved so that they can produce
maximum performance and service life.
13.2.3 How do I make sure the batteries achieve their best service life?
• Always charge your batteries completely after use.
• Charge your batteries regularly.
• Only store completely charged batteries in the vehicle.
13.0 Things to know
13.2 The batteries