Attach the front Four guard rails
As before the top guard rail is marked Red and the
bottom is marked WHITE.
It is important that we use the guard rail spacer bar.. We will
start with the bottom white guard rail. Locate two dowels
into the end. Place the space bar on the top of the side rail.
Rest the guard rail on top of this.
Then using the long black screw and screw into the back of
the ladder strut.
Now place the spacer on top of white rail and locate the top
red. Again attach using the black screw, again into the back
of the ladder strut
Once in place attach the four ladder hooks to the siderail
using the small screw (L)
IMPORTANT: The spacer bar must be used to ensure the correct, safe 70mm gap
between each guard rail. DO NOT align without this.
PIC4
WHITE
RED
Attaching The Centre Rails
SINGLE BUNK BEDS - Attaching Two Centre Rails
Each bunk have a centre rail. From the inside of the bed we need to attach metal brackets, one
either end. These are fixed using the small screws (L), these are fixed to part 13 (blue) - third
insert down from the top. Using a tape mark a centre line from each corner post, then measure
and mark 55mm from the top of the BLUE Facia(13). Now position the top of the bracket (J)
just below this mark, attach with the small screw (L)
DOUBLE BUNK BED - Attaching Four Centre Rails
Same as above except each bunk has TWO centre rails. So, rather than mark one centre point we
need to mark two. So, on part 13 Blue Facia
4ft Double Model - Mark two points 40cm from each corner post
4ft 6 Double Model - Mark two points 45cm from each corner post
Once the centre rail brackets are in place you can insert these before attaching the base slats