Stricker Crossbike Series, Instructions For Use Manual

Page: 24 / 36

22
R&E Stricker Reha-Entwicklungen GmbH Power Assist Devices
Operation
Fig. 38: USB-Port on Display
The USB charging socket on the display can only
be used when the system is switched on. To do
this, remove the cover ( Fig. 38 ).
11.2.2 Controls light / horn and cruise
control / reverse gear
Fig. 39: Left: light (red) and horn (green); Right: reverse gear
(red) and cruise control (green)
To switch on the light on the power assist device,
press the red button with the light symbol on the
left handle ( Fig. 39 ). Press the button again to turn
the light off again. Set the correct angle by tilting
the headlight ( Fig. 40 ). Press the green button with
the horn symbol to trigger the horn.
Fig. 40: Adjustment of the inclination of the lamp with
integrated horn
To activate reverse gear, press the red button on
the right handle. Press the button again to turn the
reverse gear off. The engaged reverse gear can be
recognized by an acoustic signal (beeping) and the
red glowing signal on the controler (reverse light).
( Fig. 41 ).
Fig. 41: The reverse light on the control lights up when reverse
gear is activated
The cruise control can be activated with the green
button. When the cruise control is activated, it
saves your current speed and maintains it. If
you press the button again, the cruise control is
deactivated. The cruise control is also deactivated
by actuating the brake with an interrupter contact
(brake on the right hand grip). If you use the throttle
while the cruise control is active, the power assist
device will not accelerate. If the throttle grip is
turned back to the zero position after accelerating,
the cruise control is deactivated.