10
Street
Strider
Summit 8r / Sprinter 3r Owner’s Manual
pole
(Fig. 3-8a)
, then make adjustments and tighten clamps.
IMPORTANT: When finished adjusting strider poles, make sure
the upper right and left pole positions are mirror images
(Fig. 3-8b)
.
Strider poles can be readjusted to try different positions
when riding the
StreetStrider
. When the strider poles are aligned, the hand brake lever and twist grip shifter positions can also be
adjusted to suit the rider. The brake lever clamp requires a 5 mm hex wrench and the right side twist grip shifter requires a 3 mm
hex wrench for adjustment
(Fig. 3-8c)
. Once the brake levers are positioned, rotate the twist shifter so that the gear number is
facing the rider, then tighten.
Installing the Rear Wheel – Sprinter 3r (see next section for Summit 8r)
Figure 3-9. Installing the rear wheel – Sprinter 3r
Figure 3-10. Installing the rear wheel – Sprinter 3r (con’t)
Figure 3-11. Installing the rear wheel – Sprinter 3r (con’t)
Unscrew the hub nuts on each side of the rear wheel so there is a ~1 cm section of axle thread showing
(Fig. 3-11a)
that will be
slid into the frame dropout slot. Open the rear brake with the quick release lever so the tire can slide between the brake pads
(Fig. 3-11b)
. With the wheel partly inside the frame, thread the chain around the hub sprocket
(Fig. 3-11c)
.
Figure 3-12. Installing the rear wheel – Sprinter 3r (con’t)
Raise the rear wheel so the exposed axle slides into the frame dropout, making sure the yellow non-turn washer on the left side
is outside the dropout
(Fig. 3-12a)
. Pull the wheel rearward to make the chain taut and center the wheel, then tighten the hub
nuts using the 15 mm open end wrench
(Fig. 3-12b)
. Insert the push rod, located in the screw bag, into the right side of the rear
axle
(Fig. 3-12c)
.
Remove ties and packing material from the
rear triangle
(Fig. 3-9a)
and from the chain
(Fig. 3-9b)
. Thread the shifter cable along
the frame
(Fig. 3-10a)
and through the
hanging loop of chain
(Fig. 3-10b)
, and
secure the cable to the cable boss
(Fig. 3-
10c)
with the black plastic cable clips
located in the screw bag.
