Street
Strider
Eclipse and JET Owner’s Manual
9
Figure 3A-4 a, b, c. Attaching the outboard rod ends
Figure 3A-5 a, b, c. Attaching the outboard rod ends (con’t)
Attaching the Bottle Cage
i
.
Figure 3A-6 a, b. Attaching the bottle cage
Unfolding the Head Tube
.
Figure 3A-7 a, b, c, d. Unfolding the head tube
Collapsing the Telescoping Strider Ski
.
To collapse the telescoping strider ski, place the Eclipse on the ground (Fig. 3A-8a), then lean it slightly to left side to locate a
button on the underside of the strider ski near the quick release lever (Fig. 3A-8b). Open the quick release lever, depress the
button, then slide the telescoping tube into the strider ski (Fig. 3A-8c) until the button comes out of the hole near the crank (Fig.
3A-8d), locking the telescoping tube into place. Then tighten the quick release lever.
With the 4 mm hex wrench, unscrew
the bottle boss screws from the frame
(Fig. 3A-6a), retaining the washers.
Insert the screws plus washers into
their holes in the bottle cage, align
them straight into the frame bosses
and screw them in (Fig. 3A-6b).
First move the upper strider poles
away from the rear wheel by opening
the quick release levers on the strider
poles, rotating the strider poles (Fig.
3A-7a), then locking the levers. Lift up
the head tube (Fig. 3A-7b), then
close the quick release joint lever as
follows: holding the quick release
lever, slide the T-pin all the way to the
right (TERMINOLOGY: The right
and left sides of the Eclipse refer to
the sides when standing on the
Eclipse facing forward) edge of the
frame (Fig. 3A-7c). Lift up the stem
and fit it into the slot on top of the joint
with the lever pointed up. Then lock
down the lever tightly towards the
front (Fig. 3A-7d). NOTE: The serial
number is stamped on the head
tube under the quick release joint.
Record your serial number in this
Owner’s Manual.
