background image

 
6. 

Check Unit Operation

 

 
 

 
 
1-ORANGE 

- Turns solid once the unit acquires a 

cellular signal.  If this light is continuously blinking check 
for proper installation of the VTU and be sure the data 
account is active. 

2-GREEN

 - Turns solid once the unit acquires a GPS 

signal. If this light is continuously blinking verify proper 
VTU mounting and that the “GPS THIS SIDE UP” is 
facing the sky. 
 
After all of the lights are solid turn the vehicle off, then 
turn it back on and verify the installation. 
 
Note:  When the VTU is installed, it can take up to 20 
minutes for the GPS to acquire its position after initial 
power-up.  Subsequent position acquisition will be less 
than 30 seconds of the vehicle start-up. 

1  2 

 

How To Verify Correct Installation 

 

1.

   

Log on to 

http://install.insightmobiledata.com

This website will allow you to test the installation of the 
Vehicle Tracking Unit. 
 

2

.  

Enter the 15-digit IMEI number from the Vehicle 

tracking unit in the space provided. The IMEI number 
can also be found on a sticker located on the first page 
of the customer Activation Guide. 

 

 

Summary of Contents for VTU

Page 1: ...lease contact your local installer Do not install VTU in locations that interfere with airbag operation This could cause a risk of accidents and injury Use only specified fuse When replacing the fuse please ensure the amp rating is the same as the previous fuse Cautions Do not let wires get punctured by screws or caught in moving parts Turn car ignition off before making connections Connect the Re...

Page 2: ...s facing the sky This is marked by a sticker on the VTU showing GPS THIS SIDE UP 3 Connect the Wires to the Vehicle Use the wiring harness provided with the installation kit DO NOT PLUG THE POWER CABLE INTO THE VTU AT THIS TIME Connect the wires according to the following table See Wiring Diagram for details 4 Optional Connections Connect GREEN input for notification of vehicle alarm activation Co...

Page 3: ...icle off then turn it back on and verify the installation Note When the VTU is installed it can take up to 20 minutes for the GPS to acquire its position after initial power up Subsequent position acquisition will be less than 30 seconds of the vehicle start up 1 2 How To Verify Correct Installation 1 Log on to http install insightmobiledata com This website will allow you to test the installation...

Page 4: ... starter disable equipment is installed Unlock Door Unlocks door if optional door unlock circuit has been installed Troubleshooting The StreetEagle GPS tracking unit has 2 LEDs on the front of the unit that indicates proper operation Orange Blinks then turns solid when cell signal is acquired Green Blinks then turns solid when GPS signal is acquired Both lights should be lit solid during proper op...

Reviews: