14
5.3 BOILER CASING mod. 160 GT/JB-270 GT/JB (Fig. 5)
•
Fit the panel (1D) by hooking the upper profile to the square profile and the lower to the boiler fixing.
Repeat the same procedure for panel (1S).
•
Fit the panel (2D) by hooking the upper profile to the square section and inserting it in the slots in the lower
panel. Repeat the procedure for panel (2S) with the burner-control panel connection cables passing through the aper-
ture
(for the wiring harness please refer to the control panel diagram and to the standard plug connection kit).
•
Unwind the thermostat capillaries, fit the control panel to the side, fastening with the screw, then insert
the bulbs in the boiler pockets. Fit the upper panels (4S and 4D).
•
Mount the panel (5); attach the support bracket (6) to the corner of the frame base, position the panel
(7D) and then the panel (7S) with plate attached to its side panels. Screw on tightly and plug the holes
with the appropriate caps. Attach the front/central panel with the plate (8) and the front/lower
panel (9). Finally, screw the document holder (10) on to the opposite side to the control panel.
Summary of Contents for ML 125 GT
