w w w . s t r e a m l i n e s u p p l i e s . c o m . a u
9
Installation
POSITIONING AND CONNECTIONS
Before installation the Manufacturer strongly recommends to check the water
supply system and the electrical connections. Check the mains pressure which should not
exceed 600 kpa, otherwise it is recommended the installation of a water pressure reducer.
The machine must be installed with a mains electrical switch with adequate fuses.
Attention: the machine must be connected to an efficient earthing
system (yellow-green-cable)
.
Check the efficiency of the main drain hose. Then proceed with the connection of the
water drain hose to the machine.
Hydraulic connections:
- water inlet 3/8”
- water drain hose internal Ø 14 mm.
The machine must be installed on a stable surface. Find a good position for the water
filter. Connect a valve to the pipe. Connect the pipe to the water inlet connector . Con
-
nect the pipe to the discharge receptacle and then onto the drain system. Put a drain
under the water filter discharge pipe and let out the water for a few minutes to clean the
resin. Fit the electric connection between the electrical supply and the switch.
electrical
connection
to the mains
Mains switch
(not provided)
Electric
supply cable
Main switch
Water inlet
connection
Water
drain vessel
Water
drain hose
Water
inlet valve
Water feed
from the mains
Water filter
Pipe from water filter to
water inlet
