LUKAS II
User‟s manual
September 2009
Version 1.2
8
EN
GLI
SH
EN
GLI
SH
EN
GLI
SH
Applying the Lukas to situations with rapid changing temperatures can result in
condensation (small amount of water) on the inner and outer surface of your device. To ensure a
long lifetime of your Lukas, this should be prevented. In case of such a scenario, wait until you
device is „dry‟ before you use it again.
2.3 Configuring your Lukas for the first time
O n e m o m e n t . .
Press the On/Off button to switch the Lukas on. First you get a
message on the LCD “One moment..”. Just wait for a few
seconds for the device to initialize itself.
If you use the device for the first time (or the Lukas has not been configured), the first step of the
configuration wizard is shown (see further in this paragraph).
Depending on the wizard choices, you only see the steps which are applicable. In the explanation
of the wizard part it is described in which situations the step is shown.
If you want to change a setting at a later stage, you can do this via the Setup menu. This subject
is described in the next chapter.
In
Figure 2.1
below, the menu buttons of your Lukas are depicted. Appended to the right are the
names they are referred to as in this manual.
1
– OK button
2
– Menu-Down button
3
– Mute button
4
– Menu-Up button
5
– Volume-Down button
6
– Volume-Up button
7
– On/Off button
Figure 2.1:The Lukas menu buttons
E n g l i s h
Step 1: Language setup
As default the wizard will start with [English]. Press OK button to
confirm the language preference (in this case [English]). You
could also choose between [Dutch] and [German] by using the
Menu-Up/Down buttons.
T e l e p h o n e
Step 2.0: Lukasmode setup
The Lukasmode is related to the method the device should use
to access the internet. There are two possible modes
[Telephone]; in case you are using Dialup connection and
[Ethernet] when using ADSL/cable. You can switch between the
two by using the menu up/down buttons.
Press OK button to confirm your choice. The choice will also
affect which wizard menu is shown next.
In case of [Telephone], the next menu would be the country
setting, in case of [Ethernet] you can skip the two coming steps
and go directly to step 3.