Turning on and shutting down
the scanner
Turn the scanner on by pressing the scanner button. The indicator light at the back of the scanner will turn blue.
After a short while, the scanner will connect to the MOVE+/POD and the indicator light will turn green.
Action desired
What to do
Notes
Wake up the scanner
Press the scanner button
The Indicator light at back of scanner
turns on (blue, then green when connected to PC)
Turn the scanner off
Press the shut-down button
on the user interface or take out
the battery.
Click the scanner icon in the top right corner and the
shut-down button will appear on the screen, or follow
the menu bar steps: More > Settings > TRIOS > Scanner
Management > Turn off scanner
Automatic shutdown
of the scanner
The scanner will shut down automatically after approx. 10 minutes when not connected to a 3Shape TRIOS
®
system i.e.,
the status light at the back of the scanner is blue. If the scanner shuts down unintentionally, you can turn it back on
by pressing the scanner’s button. The scanner will reconnect to the PC after approx. 10-20 seconds. Once the scanner
has been reconnected, instant-heat technology enables the system to be scan-ready in seconds.
If the scanner is connected to a TRIOS system, the scanner will not power down in order to keep the tip warm and
ready (i.e., the status light at the back of the scanner is green). Please note that the scanner will consume battery
while in stand-by mode.
Inserting the WI-FI adapter
into the PC (POD systems)
Insert the Wi-Fi USB adapter delivered with the scanner into a free USB slot on the PC.
The Wi-Fi adapter (that goes into the USB port) must be connected directly to one of the USB ports on the PC. Do not
insert any form for hub or similar hardware between the adapter and the PC, as this can make the connection
unstable.
Important note:
Use the USB slot furthest away from the position of the scanner mounted in the POD (as shown in
the picture below). If the Wi-Fi adapter is too close to the scanner (approx. 30cm/12” or less), then the wireless signal
may b too strong and cause temporary loss of the connection to the scanner.
Make sure that you do not apply mechanical stress (bend) to the WI-FI adapter. This may accidentally happen
when moving e.g. a laptop.
7
