STRATO LCD3207, Operating Instructions Manual, Page: 4 / 33

4
Hold the power connector when removing the power cable:
Pulling the power cable itself may damage the wires inside the cable and
cause
fire or electric shock.
Do not touch the connector with wet hands:
To avoid risk of electric shock.
Insert batteries in accordance with instructions:
Insert the batteries with correct polarities (positive and negative ).
Incorrect polarities may cause breakage and leakage of the batteries,
injure users and contaminate the remote control. Remove the batteries
if the product will not be used for an extended period. This will prevent
leakage and consequential damage.
Do not block or cover the vents:
Blocking the vents may cause overheating and fire . Do not install the product
in a place with little or no ventilation. Never cover the vents
with towels, blankets or dusters.
Unplug the connector:
Unplug the power connector when the product will not be used
for a long time.
ATTENTION
Unplug the connector
Unplug the connector
Use extreme care to make sure you are never in a position where your body (or any item you
are in contact with, such as a ladder or screwdriver) can accidentally touch overhead power
lines. Never locate the antenna near overhead power lines or other electrical circuits. Never
attempt to install any of the following during lightning activity:
a). an antenna system; or
b). cables, wires, or any home theater component connected to an antenna or phone system.
Always make sure the antenna system is properly grounded to provide adequate
protection against voltage surges and built-up static charges.
Antenna lead-in wire
Antenna discharge unit
Grounding conductors
Power service grounding
electrode system
Electric service equipment
Ground clamp
Ground clamp