Tray Maintenance
Replacing Tray Sheets
Page 65
© Copyright 2022 Stratasys. All rights reserved.
16. Using the 4 Nm torque drive, tighten the 8 bolts in a star pattern until the bolt heads are
flush with the tray bottom.
Figure 16: Tighten bolts
17. Tighten the tray bolts, using the same star pattern shown above, by holding the torque
driver shaft with the index finger, middle finger, and thumb. Tighten the bolts until they are
finger tight.
Figure 17: Finger tighten tray bolts
18. When all eight bolts are finger tight, use the 4Nm torque driver, in the same star pattern, to
torque all bolts to 4Nm.
19. Repeat tightening all bolts to 4Nm in a circular pattern two times.
4
8
3
7
5
2
1
6