Basic User Operations
Post-Print Procedures
Page 47
© Copyright 2022 Stratasys. All rights reserved.
Removing/Emptying the Resin Tray
Resin can be left in the tray between prints. However, if a part fails or if you need to switch to
another resin, the tray should be removed and cleaned. The resin can be filtered and reused.
1. To release the tray, tap
Release Tray
on the touchscreen. This will disable the magnets for
5 seconds.
2. Gently remove the tray with uncured resin from the printer and carry over to the cleaning
area.
3. Using a 190 µm paint filter, pour any remaining resin through the filter and into a small
plastic container. See
.
Figure 27: Empty resin tray
4. Pour the filtered resin back into its original container using a funnel.
WARNING: Skin contact hazard
Prolonged contact with resin can cause skin irritation. Do not continue before putting
on protective gloves.