Application
Instructions for use • LED Headlight KS70 • MVZ182_EN_V1.0_03-2021_IFU_CE-MDR
15
6 Application
6.1 Using the product
Switching on the LED headlight
1.
Switch on the LED headlight using the pushbutton on the control unit.
2.
Press the pushbutton again to switch off the LED headlight.
Two fully charged batteries enable an operating time of approx. 5 hours at luminous
intensity setting 3. If the battery is empty, the light flashes briefly 3 times every 2 minutes.
The brightness of the headlight does not change during operation.
Setting the luminous intensity
ü
The LED headlight must be switched on.
To set the required luminous intensity, press the pushbutton on the control unit repeatedly.
Three different brightness intensity settings can be set.
ð
The luminous intensity set in each case is shown by the status LEDs which light up for
approx. 3 seconds: 1 LED = luminous intensity 1, 2 LEDs = luminous intensity 2, 3
LEDs = luminous intensity 3. The LEDs then change back to green to indicate the
battery’s charging capacity.
The sequence of luminous intensity settings does not start at intensity setting 1, but is 2 -
3 - 2 - 1 - 2 - 3 ...
When switched on, the headlight is set to the last luminous intensity setting used.
6.2 Monitoring the battery charge state
The battery pack capacity is indicated by the status LEDs on the control unit.
LED status
Battery capacity
3 LEDs light up green
Approx. 65% – 100%
2 LEDs light up green
Approx. 30% – 65%
1 LED lights up green
≤ 30%
1 LED flashes continuously,
headlight flashes briefly 3 times every 2 minutes
Battery empty
When the headlight starts flashing, there is a maximum remaining battery life of
10 minutes. Switch off the headlight and charge the batteries. If the LED headlight is to
be used further, the batteries must be replaced. It is not possible to charge the batteries
during operation.
