P.3
Binding Procedure
2.4Ghz 6 Channel Transmitter and Receiver
Put 8 X AA Batteries into the transmitter battery compartment.
Insert the “Binding Plug” into the battery socket on the main receiver.
Turn on the receiver by connecting the battery to the ESC.
(the LEDs on both receivers should be flashing, that means they are in searching mode)
Press and Hold the binding button on the transmitter while switching on the transmitter.
In about 10 seconds, they should bind correctly. The LEDs on both receivers should
become solid, that means the binding process has completed.
Release the binding button on the transmitter, and remove the “Binding Plug” from the
receiver.
Plug in the servos and run simple test, if the test failed, please repeat the binding proecess.
1.
2.
3.
4.
5.
6.
7.
The receiver must be bound to the transmitter before use. Binding is the process for the
transmitter and receiver to recognize each other. Once bound, the receiver will only
connect to the bound transmitter. The Transmitter and Receiver you received have
“ALREADY” bound. If you need to re-bind the transmitter and receiver, please follow the
following steps :
Battery
Main
Receiver
Receiver
Module
“Binding Plug”
Binding Button
