57
5. After using the washer
5.1 Stop the pressure washer
1. Switch off the engine: turn the ignition switch on the
gasoline engine to „OFF“.
2. Close the tap.
3. Operate the spray gun until the wasser is depressuri-
zed.
4. Lock the safety catch.
5.2 Disconnecting supply lines
1. Shut the fuel cock.
2. Remove the water hose from the washer.
5.3 Storing the washer (frost-protected)
1. Store the pressure washer in a dry room without danger
of frost.
IMPORTANT!
If the high-pressure washer is stored in a room with tem-
peratures around or below 0°C, anti-freeze should be dra-
wn into the pump beforehand:
1. Remove the water inlet hose from the washer.
2. Remove the lance.
3. Start the washer and stop it again after max. one
minute.
4. Connect the suction hose to the water inlet of the was-
her and place it in a tank containing anti-freeze.
5. Start the washer.
6. Hold the spray gun over the tank containing anti-freeze
and activate it to start suction of anti-freeze.
7. During suction operate the spray gun two or three
times.
8. Lift the suction hose from the tank containing
anti-freeze and activate the spray gun to pump out the
remaining anti- freeze.
9. Stop the washer.
Detergent can be added by means of the detergent injec-
tor.
1. Dilute detergent according to the manufacturer‘s
instructions.
2. Set the pressure to the lowest setting on the lance.
CAUTION!
Never allow detergent to dry on the surface to be cleaned
as this may cause damage.
Original instruction
