StorageTek L180, Service Manual

Page: 120 / 266

Hand-Camera Assembly
4-30 Fifth Edition 95897
Removal
CAUTION:
Possible equipment damage: You will need one of the shipping pins that were
removed during installation. Ask the customer for the pin. If the pin is not available,
hold the Z belt when removing the hand-camera assembly. Once the hand has been
removed, the Z carriage will be pulled to the top of the column and could be
damaged.
1. Review the information under “Before Beginning” on page 4-2 .
2. Remove power from the library by pressing down on the power switch.
3. Rotate the Z column until the hand is on the right side of the column.
4. Carefully raise the Z carriage until the shipping pin holes are aligned.
5. Insert the shipping pin through the Z column into the Z carriage.
C67178
E67137
1