Figure 6
NOTE: DO NOT install the
cover onto the frame of your
building
in
high
wind
conditions. A slight breeze is
the most advantageous for
cover installation. To take
advantage of the breeze,
pull the cover up over the
arches with the breeze
blowing in the cover like a
sail filled with air.
1.
Put the Roof cover (part
code 11) EVENLY,
CARRFULLR AND
SLOWLY on the frame.
Adjust the cover so that it is square and evenly centered on the frame.
2.
Use Rope (part code 21) to knit the cover on the two sides of the peak arches through all the
holes.
3.
Cut 3 pockets according to the position of the base plates and insert the Lower Tension Tubes
(part code 9) into the pocket of roof cover. Then use the Ratchet (part code 8A) to fix the
Lower tension tubes like the
Figure 7
. Finally install the
Plastic plug (part code 18) for into
two ends of the
Lower tension tubes. Loosely secure the Nylon Band (No.17) in the ratchet on
the base plates. DO NOT TIGHTEN. Finally adjust the cover so that it is square and evenly
centered on the frame.
NOW THE INSTALLATION IS FINISHED, PLEASE ASJUST THE BASE PLATES VERY MONTH.
