Revision031417
3
MOUNTING AND WIRING THE LIGHT
NOTE: DO NOT MOUNT ON THE GROUND, RECOMMENDED INSTALLATION HEIGHT IS 6 ½ FEET TO 10 FEET
1.
Turn off power to the circuit breaker box. DO NOT rely on only the switch power being turned off.
2.
Install the cross bar (E) to the junction box and secure with the (2) mounting screws (I).
If installing to a wall or
building, pre-drill holes and use appropriate masonry plugs, now install the cross bar to the surface using the (2)
mounting screws (F).
3.
On the cross bar you will see a green/yellow wire (labeled GND) this is your ground wire, use a wire nut (H) to connect
to the house ground wire (typically copper).
For proper connection, place wire nut over wires and twist clockwise
until tight.
4.
Connect supply wires with wire nuts (H) as shown in the figure above.
Black supply wire connects to the Black power supply wire (Live)
White product wire connects to the White supply wire (Neutral)
5.
You may use the optional gasket (D) at this time.
6.
Install the light fixture (A) to the cross bar grounding screw (F). Use the silicone sealant around the perimeter of the
light to seal for moisture.
7.
Turn on your electricity after install has been completed.
