5
Revision102715
PRODUCT SPECIFICATIONS
•
Detection Method: PIR (Passive Infrared)
•
Detection Range: Maximum 50ft
•
Detection Angle: 180°
•
LED Angle: 120°
•
Time Adjustment: (minimum) 5 seconds to (maximum) 12 minutes
•
Operating Voltage: 110
–
240 volts
•
IP Rating: 44
•
Warm Up: 50+/-15 seconds
TROUBLE SHOOTING
Problem
Possible Cause
Possible Correction
Light does not come on
1.
No power to the fixture
2.
Fixture is sensing too much
light
1.
Confirm wall switch is on
2.
Cover photocell, unit should
come on. Unit may need to be
relocated.
Light stays on
1.
Area is too shaded
1.
Adjust the LUX setting
Light does not detect motion
1.
The sensor may not be aimed
correctly
1.
Adjust the LUX setting
PRODUCT MAINTENANCE
To clean the surface of the light, use mild soap and water.
Do not use scouring pads, powders, steel wool or any other abrasive materials. Do not immerse in water.
For any further questions please contact us at 855.652.6164, Monday through Friday, 7am to 4pm Mountain Standard Time.
PRODUCT WARRANTY
Keystone Group will cover any manufacturing defect for a period of three (3) years from the date of purchase with original proof of purchase.
Keystone Group will either repair or replace your product at our discretion. The warranty is not transferable and is only valid to the original
purchaser. This warranty does not apply to the following; acts of God, product that has been modified, opened, disassembled or unauthorized
repair, products not used in accordance with the provided instructions, damages caused by shipping, improper handling, accident or misuse.
The finish of any part of the product, scratches, weathering, corrosion, discoloration, fading, these are all considered normal wear and tear.
This warranty does not cover any damages of merchandise in transit, any damages need to be reported to the carrier and a claim needs to be
filed with the carrier.
FCC Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following 2 conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning:
Changes or modification to this unit not expressly approved by the party responsible for compliance could void the user’s aut
hority to operate
the equipment. NOTE: This equipment has been tested and found to comply with the limited Class B digital service, pursuant to Part 15 of the
FCC Rules. Their limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on; the
user is encouraged to try to correct the interference by one or more of the following measures: reorient or relocate the receiving antenna.
a Keystone Group product Erie, CO