ASSEMBLY INSTRUCTIONS
Estimated assembly time: Approximately 15 minutes
1. Place the fountain pedestal on a flat, level surface and
place the pump, with the outlet facing upwards, and lights
unit into the bottom of the basin making sure the flow rate
of the pump is set to the maximum (+) position (if
applicable).
2. Attach two lamps to the clips on each side of the basin and
route the third lamp cord and the pump cord out through
the side hole in the back of the basin. Route the pump
power cord through the cord slot on the back side of the
pedestal.
3. Route the PVC tube attached at the bottom of the fountain
upright through the center hole in the pedestal and connect
it to the pump outlet.
4. Place the fountain upright flat on the pedestal noting to
align the rod on the underside of the fountain upright with
the hole in the pedestal. Secure the fountain upright to the
fountain pedestal using the two screws and washers
provided.
5. Run the third lamp cord up the back of the fountain upright
and through the hole, and secure the lamp to the clip in the
upper spill basin. Insert the rubber stopper into the hole,
and wedge the light cord into the cord notch.
6. Place the pump cover in the back wall of the basin to
conceal the pump and cords.
7. Fill the basin with clean water. The water level should be
approximately one inch (1”) below the top edge of the
basin.
8. Connect the pump cord to the transformer and then
connect the transformer to a GFCI outlet
.
The fountain
should start to flow.
9. If applicable, adjust the flow rate of the pump to the desired
level. Remember to always disconnect the pump from the
power source before making any adjustments.