OPERATING
your Stollar Juice Presso™ BJP500
Wash and prepare your selection of fruit and/or
vegetables: fruits with hard or inedible skins
such as citrus fruit and melons should be peeled
before juicing.
Pineapple can be juiced with or without the rind
removed. Fruits with pits, hard seeds or stones
such as nectarines, peaches, mangoes, apricots,
plums and cherries must be pitted before juicing.
Ensure the juice extractor is correctly assembled
with the juice jug and pulp container under the
spouts.
Cut fruit and vegetables into pieces that will fit
down the feed chute. As a guide, apples should
be cut in to quarters.
Push the “On” button.
With the motor running gently guide food down
the feed chute. To extract the maximum amount
of juice, always push the food pusher down
slowly.Do not exert excess pressure, the fruit or
vegetable should almost be pulled down by the
screw.
1.
2.
3.
4.
5.
As the fruits and vegetables are processed, juice
will flow into the juice jug and the separated pulp
will accumulate in the pulp container.
WARNING
Do not operate juicer longer than 20 seconds
before inserting ingredients.
Immediately after use, slowly pour a glass of
water down the feed chute. Ensure that there is
a separate jug under the spout as the water will
pour directly into the juice jug that you juiced
into. This has a cleaning aspect and will help
when cleaning the strainer.
6.
7.
If the fruit or vegetables become jammed in
the screw and the juicer stops operating, press
the “off” button. ensure that the juicer comes
to a complete stop. Press the “rev” button and
hold it until the fruit or vegetables become
dislodged.
the screw will move in reverse and release
the food that is caught in the screw. once the
food is released, press the on button and start
juicing again.
•
•
NOTE
IMPORTANT
Do not load the feed chute with food until the
motor is running.
If you are making different fruit juices you
can pour a glass of water (about 200 ml) in
between the different juices to rinse any left
over flavours. It is not always necessary to
completely clean the juicer in between making
multiple juices.
NOTE
OVERLOAD PROTECTION
This protection device safeguards against
overloading the motor with excessive loads.
If overloading occurs, the motor will stop. The
overload protection will automatically de-activate
the motor. When this occurs, unplug the power cord
from the wall outlet and allow the appliance to cool
for at least 1 hour. Then reconnect the power cord to
the wall outlet. Then recommence normal use.
OPERATING YOUR STOLLAR JUICE PRESSO™ BJP500
