STOK Quattro SGP4032N, Operator'S Manual

Page: 11 / 80

11
ASSEMBLY
Fig. 7
STEP 2: ASSEMBLING SIDE PANELS TO THE
BASE
See Figure 6.
 Slide the tabs into the slots then sit the panel on the base
aligning the holes in the tabs at the bottom of the right
side panel with holes on the left side of the base.

Slide bolts, M5 x 12 mm (HH), three per side, through
both the tab and into the base. Tighten securely.
 Repeat above steps to install the left side panel.
STEP 3: ASSEMBLING THE FRONT AND
REAR PANELS
See Figures 6 - 7.
Installing the rear panel:
 Place two bolts, M5 x 12 mm (HH), through the side of
the rear panel and into the side panel. Tighten securely.
Repeat for the other side.

Place two bolts, M5 x 12 mm (HH), through the bottom
of the rear panel and into the base. Tighten securely.
Installing the front panel:
 From the front of the base, align the holes in the front
panel with the holes at the top of the side panels.

Secure the front panel to the side panels using four bolts,
M5 x 12 mm (HH).
FRONT
PANEL
BOLT
(HH)
Fig. 6
REAR
PANEL
BOLT
(HH)
LEFT
SIDE
PANEL
RIGHT SIDE
PANEL
TAB
SLOT