7
SECTION 3
INITIAL SET-UP AND OPERATION
3.1
OPERATOR’S SAFETY
PRECAUTIONS
SAFE OPERATION IS NO ACCIDENT; Observe these
rules:
A.
Know the freezer.
Read and understand the
Operating Instructions.
B.
Notice all warning labels on the freezer.
C.
Wear proper clothing.
Avoid loose fitting garments,
and remove watches, rings or jewelry, which
could cause a serious accident.
D.
Maintain a clean work area.
Avoid accidents by
cleaning up the area and keeping it clean.
E.
Stay alert at all times.
Know which switch, push
button or control you are about to use and what effect
it is going to have.
Figure 9. Controls
F.
Disconnect electrical cord for maintenance.
Never attempt to repair or perform maintenance on
the freezer until the main electrical power has been
disconnected.
G.
Do not operate under unsafe operating
conditions.
Never operate the freezer if unusual or
excessive noise or vibration occurs.
3.2
OPERATING CONTROLS AND
INDICATORS
Before operating the freezer, it is requires the operator
know the function of each operating control. Refer to
Figure 9 for the location of the operating controls on the
freezer.
WARNING
THE OFF-SERVE SWITCH MUST BE PLACED
IN THE
OFF
POSITION WHEN
DISASSEMBLING FOR CLEANING OR
SERVICING. THE FREEZER MUST BE
DISCONNECTED FROM ELECTRICAL SUPPLY
BEFORE REMOVING ANY ACCESS PANEL.
Clean-Off-Serve Rocker Switch
Red Light (Push to Freeze)
Green Light (Ready to Serve)
Low Mix Light
Front Door Interlock Switch
Actuator (located between bar-
rels behind stainless steel
panel)
Spigot Switch (behind panel)
Activated by Spigot Handles
Clean-Off-Serve Rocker Switch
Red Light (Push to Freeze)
Green Light (Ready to Serve)
Low Mix Light
High Pressure Reset But-
ton (under lower front panel)
Water Cooled Only
Ê
É
Ë
Ê
Æ
Ì
Å
Ì
Ë
È
Ë
Ë
Ë
Dispense Rate Adjusters
