Stocks AG Turbo Jet 10 i-CON, Operating Manual And Parts List

Page: 14 / 30

14
14 Machine components (Page 1 of 2)
Feed Motor
The feed motor can be turned ON or OFF, either manually via the head unit, or automatically by the remote
mounted spring finger switch which can be fitted to the linkage or the implement. The feed motor must be
switched ON via the head unit for the spring finger switch to work automatically.
Hopper Agitator
The internal agitator is powered independently by a separate motor. Its purpose is to prevent seed becoming
compacted in the hopper and bridging (not flowing). It is recommend for all grass and grass seed mixes, or
other seed that may bridge in the hopper, but it is not required for free flowing seeds such as OSR, clover,
stubble turnips or similar, or granular products. If you use the agitator in the field, also use it when
calibrating .
Spring Finger Switch
The switch should be mounted to a suitable place on the implement or linkage of the tractor, thus deflecting
the spring, and automatically switching the feed motor off or on accordingly as the circuit is made or broken.
Position the finger switch so that the tip of the spring comes into contact with the moving part of the
implement or linkage when lifted out of work, and remains deflected until the implement is lowered back into
work. NOTE. Ensure that there is sufficient and positive deflection on the spring to prevent accidental
switching ON or OFF if the implement moves slightly up or down in work.
The standard wiring as supplied for this switch is when the spring is at rest, the feed motor will run normally.
If required, the switch can work in the opposite mode by changing the position of the 2 wires inside the
switch so that the switch is out of work when the sprung is at rest.
To change over remove the PVC cover plate held in position with the retaining screw to access the wiring
terminals. Remove the 2 wires from terminals 13 and 14 and re-connect to terminals 21 and 22 (nearest
the gland nut) then re-fit the PVC cover plate. ( NOTE the area meter also stops when the feed motor stops)
12v Brushless Fan Unit
This high specification double fan fitted is has a fully water and dustproof 12v motor. Housed under the
hinged meshed cover designed for easy access, and air is drawn through the mesh intakes on the rear, front,
and sides of the cover, and underside the mounting base plate. This hinged cover can be lifted for cleaning
purposes.
Use the junction box switch to turn the fan OFF when calibrating, and ON ready for work. NOTE the fan motor
Main Power Cable
The heavy duty power cable should connect directly to the vehicle battery posts to ensure adequate 12v
supply to the fans. The in-line MAXI FUSE is 40 amp. This cable should reach to the back of the tractor in
turn this is connected to the 5m heavy duty power extension cable which then connects to the power input
flylead on the machine .
Instrument Lead
The 6m instrument lead connects to the junction box of the Turbo Jet, and runs to the control panel in the
tractor cab.
NOTE Extension power and instrument cables are available if required.
Please contact your local Stocks AG dealer for more information.
22
21
13
14