12
Mount the machine using the Base Plate.
This has 4 holes in the base to take M12 bolts (see below) use these to attach to the parent vehicle and is
attached to the chassis by 2 bolts and spacers which act as the pivot, and a removable steel pin secured by an
‘R’ clip.
Gravity fed machines;
mount the base plate at the rear of the machines to allow room for feed hoses
Air fed machines;
the base plate can be base or rear mount
Ensure there is sufficient room to tip the hopper for emptying and ensure any potential trapping
points are noted taking care not to trap hands or fingers
NOTE
feed hoses will need to be removed before tipping the hopper
The machine must be on level ground or flat surface before tipping the hopper to avoid the hopper
accidently tipping forward once the tipping pin has been removed.
To tip the hopper, remove the pin whilst supporting the hopper, lower gently when emptying the hopper.
12 Machine Mounting
Base
Mounting
Rear
Mounting
200mm
150mm
