14
14-1 i-CON Control system
All control system components integral to the Seed Applicator Unit are factory fitted in.
The Instrument has a 4.3" Colour Touch Screen which has 4 basic menu keys (see page 16)
Separate heavy-duty power cable and head unit leads interconnect the tractor and the Seed Applicator
Unit.
The following components need to be installed during fitment (packed in hopper from factory)
i-Con Instrument; TJ117C
Instrument cables; TJ118C and TJ242A
Power Cables; FJ107E
GPS Receiver; TJ255B
Cut out Switch; TJ252
14-2 Wiring diagram
14-3 Electrical connections
Power requirement is 12 volts with a minimum continuous 30amp supply. Ensure the power supply cable is
connected direct to the vehicle battery to ensure maximum power. Connect the positive wire (fused) to the
positive (+) terminal and negative earth connection to the negative (-) terminal.
NOTE
the disc should rotate in a clockwise direction when viewed from above.
WARNING
Failure to connect to the vehicle battery may result in control function problems and possible
damage to the vehicle battery and charging system must be in good condition to achieve the best results. All
cables and controls are fitted with matching plugs and sockets.
WARNING
any modifications to the wiring, fuse holder or control system will invalidate any warranty claim
and may effect the performance of the machine
12v Disc Motor
Junction
Box
TJ119D
6m Instrument
Cable TJ242A
i-Con
Instrument
Instrument Connector
Cable TJ118C
GPS Receiver
7m Fused
Power Cable
(not used)
Feed
Motor
Hopper Level
Sensor
Cut Out Switch
OPTIONAL
Ground Speed Radar TJ233A
OPTIONAL
6m Radar Cable TJ234
