4
www.stockmastereurope.nl
IMPORTANT
:
To avoid assembly problems follow these instructions exactly. Work Safely - Do not stand the
frames upright when assembling. Place the frames in the positions as shown in the illustrations.
Step 1
-
Lay the Rear Frame (without steps) on the floor and place the Platform over the frame as shown. Check that
the side with the Flat Brace “E” is face side down. (See illustration No. 1)
Step 2
-
Fix the Tube Brace, Platform and Rear Frame together using a 10 x 20mm bolt and nut
- finger tight only.
For
ease, lift the Frame up slightly. Repeat the process and fit the remaining Tube Brace. (See illustration No. 2)
Step 3
-
Turn the Platform on its side. Place something under the Platform Rails as illustrated so the centre line of the
Rear Frame is approximately parallel to the floor. The long box may be used for this. (See illustration No. 3)
Step 4
-
Engage the Front Frame (with steps) into the Platform and fix together using a 10 x 20mm bolt and nut
-
finger tight only
. For ease, lift the Frame up slightly. Repeat this step for the other side.. (See illustration No. 4)
Step 5
-
Fix the free ends of the Tube Braces to the Front Frame using 10 x 20mm bolts and nuts
- finger tight only.
Do not tighten the 10mm bolts untill advised.
(See illustration No. 5)
Illustration 2
M10x 20
Illustration 1
E
