Copyright © 2015 ARM Ltd. All rights reserved.
Debug and Trace Configuration
STMicroelectronics STM32F756G-EVAL Board
ST-Link Debugger
Trace with ULINK
pro
For full trace capability, connect a ULINK
pro
to the board’s
Trace
connector and choose
ULINK
Pro Cortex Debugger
. Configure ETM trace for instruction tracing:
Note:
You need to lower the core clock as trace is not supported for clock frequencies above 180
MHz on this microcontroller device.
More Information
Getting Started User’s Guide
Connect using Serial Wire
Debug (SWD) by
selecting the Port
SW
.
Configure ITM Trace by
selecting the
Trace
tab
and enter the correct
CPU
Core Clock
speed
as specified in your
project. Check the
Trace
Enable
box.
