Step Two
Lock the Roller Hinges
(F5-1064) onto the Table Bed
Assembly (FS-1030)
• For ease of assembly, rest
the Table Bed against the
side of the A-frame
(Figure 3).
• Open the cam locks on each
side of the Table Bed.
• With the grooved pins facing
outward, insert the Roller
Hinges into the brackets on
each side of the Table Bed
(Figure 4). The Roller Hinges
must slide between the cam
locks and the brackets.
• Make sure the Roller Hinges
are in the same hole setting
on both sides.
• Push down on the cam
locks (Figure 4A) to secure
the hinges. Figure 5 shows
the Roller Hinges engaged
correctly (in setting C).
Refer to the Owner’s Manual
for an explanation of the hole
settings. If you are unsure, use
“C” to start.
7
ASSEMBLY
Figure 3
Figure 4
Figure 5
A B C
cam locks
4A
10
ASSEMBLY
Step Five
Install the Front Ankle Assembly
• Gather the Ankle Bar (FS-1060),
Black Plugs (F5-1056), Foam
Rollers (F5-1051), Bolt Sleeve
(IA-1110), and Sleeve Screw
(IA-1112).
• Stand in front of the Main Shaft
and slide the Ankle Bar over the
ratchet housing into the slot
(Figure 12).
• Align the bolt holes. Insert the
Bolt Sleeve through the holes and
secure with the Sleeve Screw
(Figure 13). Position one Allen
Wrench on the Sleeve Screw and
one on the Bolt Sleeve to tighten.
• Slide the Foam Rollers over each
side of the Ankle Bar (Figure 14).
Use a twisting motion to ease the
process.
• Insert the Black Plugs into both
ends of the Ankle Bar (Figure 14).
Figure 14
Figure 13
Figure 12
Ratchet Housing
Allen Wrench
t p
S
ne
S Y S T E M
T M
t p
S
ne
S Y S T E M
T M
pivot pin
