13
AUS
AFTER SALES SUPPORT
1300 112 534
tempo.org/support
MODEL: STR-CD70W PRODUCT CODE: 708644 06/2022
Installation (Cont.)
Fig. 2
Place the machine on solid, dry and level ground. The machine must stand perfectly
level on all four feet to ensure safe and proper operation. Incorrect installation may
cause vibrations and noise and may cause the machine to move about.
To determine whether levelling is necessary, place a spirit level on top of the dryer and
hold it upright against the housing to identify any inclinations. If the machine needs
levelling, proceed as follows (Fig. 3):
WARNING!
It is very important to level the dryer carefully, especially if your floor is uneven.
Failure to do so may result in the machine shaking and moving, or out-of-balance
problems.
WARNING!
The lock nuts on all four feet must be screwed tightly against the housing, otherwise
the machine may vibrate noisily during operation.
• Loosen the lock nut with
a spanner, turning it
anticlockwise to loosen
.
• Adjust the foot by hand until
it makes close contact with
the floor. Turn it
clockwise
to lower
the foot or
anticlockwise to raise
it.
• When the machine is level,
use a spanner to turn the
lock nut in a
clockwise
direction to tighten.
Fig. 3
Levelling the machine
Freestanding, floor level installation
• Make sure the floor surface is firm, flat, dry and stable,
and there is an appropriate wall outlet nearby. Do not
place the appliance on soft material such as foam,
plastic or carpet, as this may block the air intake.
• Carefully stand the dryer upright and slide it into
position, leaving a space of at least 200 mm between
the dryer and any wall (Fig. 2).
• If placed in a room such as a bathroom, make sure
the room is well ventilated. Also ensure there are no
obstacles that obstruct the door of the dryer.
>200 mm
